Plain guides to the DOT annual inspection. Call when you are parked, never while driving.(305) 699-5857
Get a life quote

Annual inspection

DOT annual inspection checklist

A working list for tractors and trailers, organized the way Appendix A is, with the numbers that decide a pass or a fail.

A shop inspector with a clipboard talks with a truck driver beside his tractor
Short answer

This checklist follows the 15 areas of Appendix A to Part 396, the list the annual inspection must cover. Walk each unit with it before the shop visit and fix what you find. The official inspection still has to be done by a qualified inspector who writes the report.1

Prices checked
No prices on this page
Rule checked
November 20, 2026, sections 396.17, 396.19 and 396.21, plus Appendix A
Applies to
Each tractor, trailer, dolly and straight truck, one by one
On this page
  1. 01How to use this checklist
  2. 02Brakes
  3. 03Coupling devices and steering
  4. 04Suspension, frame, tires, wheels
  5. 05Lights, glass, exhaust, fuel, load
  6. 06After the walk-around
  7. 07Questions people ask

How to use this checklist

Appendix A is written as a list of defects. If a vehicle has one of them, it does not pass.2 So each line below is phrased as something to look for and rule out. A clean line means that defect is absent. A line you cannot clear is a repair to schedule before the vehicle works again, because 396.17(g) makes the carrier responsible for keeping parts at, or promptly repairing them to, the Appendix A minimums.1

This is a preparation aid. It is not a vendor form and it is not the inspection. The annual inspection must be done by a person who meets the qualifications in 396.19, and the report that results is the record. For the report itself, see the annual inspection report form page.3

Brakes

  • Every axle that should have brakes does. No missing brake, and every shoe or pad moves when the service brakes are applied.
  • Pushrod stroke is inside the limit. Measure with the brakes fully applied, the engine off and the reservoir held between 80 and 90 psi, then compare against the chamber table. Unlisted chamber types are held to 80 percent of the rated stroke marked on the actuator.
  • Lining and pad thickness. Air drum brakes on non-steering axles need at least 1/4 inch at the shoe center, air disc brakes at least 1/8 inch. Hydraulic and electric drum brakes fail at 1/16 inch or less. Steering axle drum linings need at least 1/4 inch.
  • Lining is attached and clean. It is firmly on the shoe and not soaked with oil, grease or brake fluid.
  • No audible leaks. Listen at the chambers, hose and tubing with the system charged.
  • Hose and tubing are sound. No damage through the outer reinforcement ply, no bulge when air is applied, no cracked, broken or crimped lines, and no spliced hose.
  • Drums and rotors. No external crack that opens when the brakes are applied, and no portion missing or ready to fall away.
  • Parking brake holds. No brake on the vehicle or combination is left released when the control is applied.
  • Warning devices. The low pressure warning has to trigger at 55 psi or lower, or at half the governor cut-out setting if that is lower. The ABS lamp lights at power up, then goes out.
  • Tractor protection valve and compressor. The valve is present and working. Compressor belts, bolts, pulley and brackets are tight and intact.
  • Automatic adjusters. None replaced by a manual adjuster. A brake found out of adjustment gets its cause fixed, not just a turn of the adjuster.
  • Steering axle match. Air chamber sizes and slack adjuster lengths match across the power unit's steering axle.
A shop inspector with a clipboard talks with a truck driver beside his tractor

Life insurance for drivers

Licensed agents compare several insurance companies and call you back with prices. You decide.

Get a life quoteOr call (305) 699-5857

Coupling devices and steering

  • Fifth wheel mounting. No missing or ineffective fasteners, no movement between mounting parts, no cracked angle iron.
  • Fifth wheel coupling. Upper and lower halves move no more than 1/2 inch against each other. The handle is closed and locked and the kingpin is properly engaged. No light shows through the gap between the halves.
  • Pivot bracket and slider. No more than 3/8 inch of movement at the bracket pin or between slider bracket and base. Latching fasteners and stops are present and secure.
  • Pintle hooks and drawbars. No cracks, no welded repairs on a pintle hook, no part of the horn or eye worn down by more than 20 percent, and the latch is secure.
  • Safety chains and cables. Both are present and attached. Look for worn links, repairs made with wire, rope or tape, and kinked or broken cable strands.
  • Steering wheel free play. With the engine running on power steering, free play is within the table for the wheel size. For an 18 inch wheel that is 2 1/4 inches manual and 4 3/4 inches power.
  • Steering parts. No cracks or obvious weld repairs in the front axle beam or steering components. No loose or missing gear box bolts, pitman arm play, or loose tie rod and drag link clamps and nuts.
  • Joints. No stud nut movement under steering load and no more than 1/4 inch of non-rotational motion at a linkage point.

Suspension, frame, tires, wheels

  • Axle location. U-bolts, spring hangers and other axle positioning parts are not cracked, broken, loose or missing.
  • Springs. No broken or missing leaves, no broken coil or torsion spring, no missing rubber spring, and no leaf shifted toward a tire, rim, drum or frame. An air suspension is not deflated.
  • Torque and radius parts. Nothing cracked, loose, broken or missing, including the parts attaching them to the frame or axle.
  • Frame. No cracked, broken, loose or sagging member, and no loose or missing fasteners on the engine, transmission, steering gear, suspension, body or fifth wheel. Sliding subframe locking pins are in and engaged.
  • Clearance. Nothing, loaded or not, lets the body or frame touch a tire or wheel part.
  • Tread depth. Steering axle tires of a power unit need at least 4/32 inch at a major groove. All other tires need at least 2/32 inch.
  • Tire condition. No exposed ply or belt, separation, cut through to the ply, flat or audible leak, boot or blowout patch, regrooved tire (outside the exception in 393.75(e)), or mixed bias and radial on one axle.
  • Load rating. No tire carries more than its limit, including from low pressure.
  • Wheels and rims. No cracks, elongated bolt holes, bent or sprung lock rings, or loose, missing or stripped fasteners. No weld cracks at the disc or demountable rim.

Lights, glass, exhaust, fuel, load

  • Lighting devices and reflectors. Every one required by Part 393 works or is present.
  • Windshield. Outside the border areas, look for cracks, discoloration and anything that blocks vision. Check the listed exceptions before deciding.
  • Wipers. They run, and no part is missing or damaged enough to make them ineffective.
  • Exhaust. No leak forward of or directly below the cab or sleeper, and no part routed where it can burn or char wiring, fuel lines or anything combustible.
  • Fuel. No visible leak, a filler cap in place, and a tank held by all its bolts and brackets.
  • Load and spare. The spare, the load and the dunnage cannot fall onto the road. A front-end structure is fitted where one is required. Intermodal container locks, pins and bolsters are not cracked, loose or missing.
  • Rear impact guard. On newer trailers rated 10,001 pounds or more (built January 26, 1998 or later), the guard is present and firmly attached. Its horizontal member is no more than 22 inches above the ground, within 4 inches of each side edge, and at least 4 inches tall.
  • Motorcoach seats. On buses, every passenger seat is securely fastened to the vehicle structure.

What the inspection report must show, 396.21(a)

Who
The inspector, and the motor carrier or equipment provider
When and what
Date, and the vehicle inspected
Results
Components inspected, and any that do not meet Appendix A
Sign off
A certification of accuracy and completeness
Checked
Nov 20, 2026

After the walk-around

List what you found by unit and by Appendix A area. Repair first, then bring the unit in. If a defect would likely cause an accident or breakdown, 396.7 forbids operating the vehicle in that condition, and the carrier is the one responsible for repair under 396.17(g).4 Keep the shop's report. The rule requires it to be kept for 14 months from the inspection date where the vehicle is housed or maintained.5

Questions people ask

Can I use this checklist as my annual inspection?

No. Section 396.19 sets qualifications for the person who performs the inspection, and 396.21 requires that person to prepare a report. A checklist you fill in yourself is preparation, unless you are a qualified inspector doing the inspection under 396.17(d) and writing the report.

Is a checklist from a parts or software vendor required?

No form is required by name. The rule requires a report with specific content, listed in 396.21(a), and the inspection must cover the Appendix A items.

Do trailers need their own checklist?

Yes, each unit is inspected separately. Skip the steering, exhaust, fuel and wiper lines on a trailer and use the brake, coupling, frame, suspension, tire, wheel, lighting, loading and rear guard lines.

Sources (5)
  1. Cornell LII, 49 CFR 396.17 Periodic inspection, opened November 20, 2026. law.cornell.edu
  2. Cornell LII, Appendix A to Part 396 Minimum Periodic Inspection Standards, opened November 20, 2026. law.cornell.edu
  3. Cornell LII, 49 CFR 396.19 Inspector qualifications, opened November 20, 2026. law.cornell.edu
  4. Cornell LII, 49 CFR 396.7 Unsafe operations forbidden, opened November 20, 2026. law.cornell.edu
  5. Cornell LII, 49 CFR 396.21 Periodic inspection recordkeeping requirements, opened November 20, 2026. law.cornell.edu

Life insurance for drivers

The truck is ready. Is your family's plan?

The truck gets inspected every year. Your family’s plan deserves the same check. A licensed agent compares life insurance from several insurance companies and calls you back with prices. You decide if and when to apply.

Get a life quoteOr call (305) 699-5857

DOT Annual is run by an independent, licensed insurance agency. We are not FMCSA, CVSA, a state agency, an inspection shop, a medical examiner or a motor carrier.

A driver checks trailer lights and tires on a morning walkaround at the truck yard
CallGet a life quote